The Inlay Methods of Rings - Whats Your Style


A high-quality gemstone must be matched with sophisticated inlay technology to complement each other. The good mosaic method can express the most brilliant side of the popular diamond ring and convey the most touching emotion of the gem. The following is a brief introduction to the several gem inlay methods that are
popular nowadays.

1. Claw setting. With a long metal claw tightly holding the gemstone, it is currently popular on the market. The claw setting can be generally divided into a six-prong setting, a four-prong setting, and a three-prong setting. Nowadays, the wedding diamond ring is popular with the six-claw crown. The princess diamond gnn monogram ring can be set with a four-prong setting. Larger stones in order to secure, sometimes use two small claws into a claw, known as parallel claws. Advantages:

The metal rarely blocks the gemstone, and clearly reveals the beauty of the gemstone. It also helps the light to enter and reflect at different angles, making the gem look bigger and more awkward. Disadvantages: The claws are easy to hang on the hair or fabric. If it is platinum because it is relatively soft, it may cause the claws to deform and the stones to fall off. It is necessary to check for looseness regularly.

2. Bezel setting. Seal the waist down of the gem in the metal bracket with a metal edge, and prevent the gem from falling off with the solidity of the precious metal. This is the strongest and most traditional setting, showing the brilliance of the gemstones, glorious inside with dignified temperament. Carefully observe when purchasing a bezel setting gemstones. The tip of the gemstone should not be exposed to the bracket, otherwise, it will damage the skin or hurt the gemstone. Advantages: Safer protection of the gemstones, especially for the pavilion and waist of the gemstone, making the cheap promise rings surface smoother and the gemstones more secure. Disadvantages: more metal is required, the processing is cumbersome, the cost is high, and the light entering the gemstone is relatively small, so that the beauty of the gemstone cannot be fully reflected, and it is more suitable for older women to wear or men's ring mosaic.

3. Inserted setting. The use of the tension of the metal to fix the waist or the waist and the bottom of the gemstone. Nowadays, the popular inserted setting and V-clip setting belong to this category. Simply put, a shallow groove is formed on each side of the metal to insert the waist of the gem. Advantages: The jewels are exposed even further than the claws, sparkling with brilliance. Disadvantages: The position of the gemstone being fixed by the metal is limited, and the force point is very small. If the rabbet is too large, it is easy to cause the gem to lose or even fall off, so the inlaying in this way requires higher technology than the claw setting.

4. Track setting. Slot setting, also known as track sets, force setting, clip setting or wall setting. It is a method of first pulling out the groove on the precious metal bracket and then clamping the gem into the groove. The track setting method is applied to gemstones of the same calibre, one after the other, continuously embedded in the metal track, and the metal is supported by the two sides. It is used to set round, narrow rectangles and square gems. The groove is like a railroad track with precious stones in the middle. Advantages: This inlay makes the surface of the trim look smooth. It is a safer way, the ring is full of small diamonds, which is commonly used in this method. It has better protection for the waist of the gemstone, and it can give a neat and smooth feeling in visual effect. Disadvantages:

The grooved diamond ring is not suitable for retracting and changing the size of the hand ring. Once the curvature of the metal changes, it is easy to cause the gem to fall off. Because the groove diamond ring is similar to a track in the middle of the set of diamonds so that the middle of the stones are often not as strong as the claws.

5. Gypsy setting is also known as besmear setting, hidden setting. Gemstone couple rings are often set in gipsy settings, which are very popular nowadays. This style is more popular in the men's ring. This style of the diamond ring first inserts the gem into the hole that better covers the waist of the gemstone, and then hammers the surrounding metal to fix the gem. Advantages: It can better protect the waist of the gemstone. If it is properly set, the gem will be more stable and the appearance will be more beautiful and generous. Disadvantages: Very time consuming for setting, and easy to damage the gem when setting. The material holding the gemstone is often narrow and the gemstone is very easy to fall off.

Find your style at www.getnamenecklace.com
Powered by Blogger.